STENCIL CATALYST
PRODUCT:
Screen printing stencil catalyst.
USES:
To improve the water and abrasion resistance of screen stencils.
PROPERTIES:
- Hardens all stencils, making them suitable for water based inks.
- Increases considerably the print runs.
- Makes the stencil even more resistant to water as well as solvent based products.
- Can be used on any type of emulsion or capillary film.
- Should only be used on polyester mesh.
INSTRUCTIONS:
Prepare the stencil in the usual way (Fig. 1).
After drying, apply the HB74 Catalyst with a soft brush or sponge on both sides of the stencil (Fig. 2).
Leave the screen standing for 10 minutes, while the stencil absorbs the product. Then, eliminate the residues from the open area with an air jet, aspirator or by wiping it with a soft cloth. (Fig. 3).
To complete the chemical hardening, leave the stencil in an oven at 140°F (60°C) for 10 minutes or under infrared lamps (Fig. 4).
Note: Longer time periods and higher temperatures will further increase the stencil resistance.
RECLAIMING:
Read the MSDS before using the products.
Risk phrases:
R 36/38 – Irritating to eyes and skin.
R 43 – May cause sensitization by skin contact.
R 68 – Possible risk of irreversible effects.
Safety phrases:
S 7 – Keep container tightly closed.
S 16 – Keep away from sources of ignition – no smoking.
S 36/37 – Wear suitable protective clothing and gloves.
WARNINGS:
The Catalyst and Hardeners are corrosive. Avoid contact with skin and eyes. In case of contact with skin, wash with soap and water. In case of contact with eyes, wash immediately with plenty running water keeping the eyelids open. Keep the containers tightly closed.
ADDITIONAL INFORMATION:
This information is based on our best current knowledge. This product is solely intended for industrial use. No warranties are made or implied. Agabę will not be held liable for claims related to any party's use or reliance on information or recommendations contained herein.