REMOVABLE BLOCKOUT
FAST DRYING/STANDARD
PRODUCT:
Removable blockout (screen filler).
USES:
To block out open stencil areas.
To temporarily fill open areas that will be printed with a different color.
To touch up stencil pinholes and defects.
PROPERTIES:
- Resistant to all non-aqueous solvents.
- Ideal for all types of inks, except those containing water.
- High mechanical resistance.
- Easily removed with water.
- Fast Drying - Green.
Standard (slower drying) - Blue.
INSTRUCTIONS:
The product can be coated with an Agabe emulsion coater (Fig. 1) or with a plastic spatula when the stencil is held in the horizontal position (Fig. 2).
Dry using hot or cold air (Fig. 3).
After drying, a second coat can be applied if needed.
Use a brush for touching up the stencil.
On indirect film stencils, the Blockout must be used prior to remove the clear base.
After printing, clean all ink residues with the appropriate solvent. Then wash out with water to dissolve the blockout layer (Fig.4).
ATTENTION:
Read the MSDS before using the products.
HB20 Standard:
Risk Phrases - Not Applicable.
Safety Phrases - Not applicable.
HB20 Fast Drying:
Risk Phrases - Not Applicable.
Safety Phrases - Not applicable.
ADDITIONAL INFORMATION:
This information is based on the best of our current knowledge. This product is solely intended for industrial use. No warranties are made or implied. Agabe will not be held liable for claims related to any party’s use or reliance on information or recommendations contained herein.